6D ATR-2 Drive Helmet CLOSEOUT

6D ATR-2 FEATURES

• PATENTED ODS® Omni-Directional Suspension® technology

• SHELL – A proprietary woven blend of advanced aerospace carbon fiber, composite fiberglass, and Kevlar

•  CERVICAL SPINE RELIEF – Rear lower shell incorporates compliant zone at the cervical spine location

• CLAVICAL CUT-AWAY – Provides increased clavicle clearance.

• STERNUM PAD – Provides added protection of the chin, jaw and sternum.

•  ROOST GUARD – Provides additional face protection

•  SHEAR-AWAY VISOR SCREWS

• EMERGENCY RELEASE CHEEK PADS – Removable, washable, Dri-Lex® anti-bacterial fabric

• COMFORT LINER – Removable, washable comfort liner, Dri-Lex® anti-bacterial fabric

• AIR FLOW MANAGEMENT – 9 intake ports, and 6 exhaust ports work in unison with the Air Gap Ventilation System

• TITANIUM D-RINGS

• LIGHT WEIGHT with improved center of gravity (+/- 1250 grams Size M)

• EXCEEDS DOT, ECE, ACU AND ASTM STANDARDS

•  3-YEAR LIMITED WARRANTY

Rebuildable ODS System:

•  Patented Omni-Directional Suspension® (ODS®)
• Improved ODS design mitigates Angular and Linear Accelerations
•  Replaceable Inner EPS Liner
• Multi-impact EPP Outer Liner incorporates Isolation Damping Towers
•  Rotational Energy Management Disks reduce Angular Acceleration
•  Superior low, mid, and high velocity impact mitigation
•  Rebuild/ Crash Replacement Program

THE DYNAMICS OF 6D’S ODS ENERGY MANAGEMENT TECHNOLOGY
6D’s patented Omni-Directional Suspension (ODS) technology is a fully active, in-helmet suspension and kinetic energy management system. Engineered to uncouple the helmet’s exterior shell from the inner EPS liner, the system effectively mitigates energy transfer to the head and brain of the rider during any given accident or impact event.

Size Chart

DETERMINING CORRECT HELMET SIZE

Your helmet should fit snug and securely around the entire circumference of your head. Cheek pads should be firm against your cheek bones and offer support from the helmet moving laterally. We offer multiple shell options, cheek pads and liners for a custom fit and superior comfort. Please reference the following guide to get started. Please direct any questions to our online contact form.

[1] Use a soft tape measure to get your correct head circumference measurement. Measure horizontally around your head at a height about one inch above your eyebrows and 1/2 inch above each ear. This should give you the correct largest measurement for reference to the size chart below.

[2] Cross check the sizing chart to determine your proper size helmet.

[3] Select the helmet size that is the closet match to your head measurement. If your head size falls between two helmet sizes you should try on the smaller one first. Often times helmet pads and liners can be swapped to customize fit.

CHECKING FOR PROPER FIT

With the helmet on, go through the following to determine whether you have chosen the correct size. Make sure your head is seated all the way into the helmet and contacts the comfort liner on the crown of your head as well as the entire circumference. The cheek pads should be firm against your cheek bone area. With the chinstrap securely fastened, grasp the helmet firmly with both hands. Without moving your head, try and move the helmet up and down and side to side. You should feel the skin of your head and face being pulled over and about your skull as you try to move the helmet. If you can move the helmet around easily without this sensation the helmet is too big and you will need a smaller size. Next, try to rotate the helmet forward around your ears. It should not be possible to remove the helmet in this fashion with the chinstraps properly fastened. If you cannot adjust and fit your helmet as described above, DO NOT USE THE HELMET as serious injury or death could result. Replace the helmet with the correct size.